TI SimpleLink Sensortag Dev Kit
A low-power wireless development platform from Texas Instruments packed with ambient and motion sensors. Built around the CC2650 wireless MCU, it enables rapid prototyping of Bluetooth Low Energy (BLE), Zigbee, and 6LoWPAN IoT end nodes with minimal battery drain.
BlueRov Sensor (Temperature and Pressure)
An electronic module used to detect physical properties such as gas, light, motion, or temperature.
Electroacoustic Sonic Device from Ovono
A specialized acoustic transducers assembly designed for acoustic signal generation, ultrasonic testing, or targeted sound wave propagation in lab environments. It converts electrical signals into precise mechanical/acoustic vibrations across calibrated frequency bands.
Pi HAT ReSpeaker 2-Mics
The ReSpeaker 2-Mics Pi HAT is a dual-microphone audio expansion board for Raspberry Pi based on the low-power Cirrus Logic WM8960 stereo codec. Featuring two onboard analog microphones, far-field voice capture up to 3 meters, 3.5mm audio jack, speaker connector, user button, three APA102 RGB LEDs, and two Grove expansion ports, it powers AI voice assistant applications.
37 Sensor Kit
The 37-in-1 Sensor Starter Kit provides a comprehensive collection of input, output, and environmental detection modules for microcontroller development. Operating primarily at 3.3V to 5V, it features digital, analog, and PWM modules—including temperature, acoustic, optical, magnetic, and motion sensors—enabling rapid hardware prototyping, data acquisition, and signal processing on Arduino platforms.
Voltage Detection Sensor
The Voltage Detection Module is a compact resistive voltage divider circuit designed to step down high DC input voltages for safe analog pin measurement by 3.3V or 5V microcontrollers. Utilizing a 5:1 reduction ratio (7.5kΩ and 30kΩ resistors), it enables microcontrollers to sample external DC voltages up to 25V safely.
ACS712 Hall Effect Current Sensor
The ACS712 is a fully integrated, Hall-effect-based linear current sensor module designed for both AC and DC current sensing. Current flowing through the low-resistance internal copper path generates a proportional magnetic field, which the integrated Hall IC converts into a linear analog output voltage centered at VCC/2 (2.5V at 5V supply).
DFRobot Pressure Mat Sensor
The DFRobot SEN0296 (RP-S40-ST) is a square, ultra-thin flexible force-sensitive resistor (FSR) featuring a 40 × 40 mm active sensing area. It converts applied static or dynamic mechanical pressure into a inverse change in electrical resistance, decreasing from >10 MΩ down as force increases up to 10 kg.
GY-NEO6MV2 GPS-Module with Antenna
The GY-NEO6MV2 is a high-performance GPS receiver module built around the u-blox NEO-6M engine. It features an onboard EEPROM for saving configuration parameters, a backup battery for fast warm/hot start satellite acquisition, and a 25 × 25 mm ceramic patch antenna. It outputs standard NMEA positioning data over a UART interface.
Ultrasonic Distance Sensor HC-SR04
The Kitronik HC-SR04 is a 5V ultrasonic distance sensor module designed for non-contact distance measurement with microcontroller development boards like Arduino and micro:bit. Combining an ultrasonic transmitter, receiver, and control circuit, it delivers precise ranging measurements from 2 cm to 400 cm with up to 3 mm precision.